[title]
[message]
DonnyFL
Sam Yang .50 cal Dragon Claw A47
$50.00
Product description
Sam Yangs are known to output some crazy power. This adapter with M18x1 threads will allow you to screw on the Emperor v3. You might have need the Extender as well if Silence is a Priority!
DonnyFL
Skout | Epoch Moderator Adapter #A108
$39.99
If you prefer not to use the factory Skout moderator, you can use this adapter to allow it to screw on a different moderator with 1/2 x 20 threads.
Features:
6061 Aluminum
Black anodize
Knurled thread protector
Compatible up to .30 caliber
DonnyFL
Stainless Steel Extended Quick Disconnect w/ Foster Fitting M32
$24.99
This extended quick disconnect (QD) makes it easy for those guns with hard to reach fill nipples. A must have for FX Impacts.
1/8 BSP male threads
Max 5000 psi (Do not exceed recommended pressure)
Release collar close to 1.20 inches long
Comes with sealed washer
DonnyFL
Umarex Hammer M18x1 #A60 Moderator Adapter
$39.99
Adapters are threaded for attaching a moderator
Thread: M18 x 1
This adapter replaces the factory shroud baffle and has M18x1 threads. Comes with thread protector
DOES NOT WORK WITH THE HAMMER CARBINE MODEL
Instructions:
remove the factory shroud by grabbing onto the shroud by the front cap. When you turn the shroud counter clockwise, that should loosen the front cap. The shroud is free floating, there are no threads in it. Important thing is to remove the front cap.
once shroud is off, put a few drops of red loctite onto the barrel thread.
put the shroud back on
now take new shroud adapter and tighten onto barrel. Let it dry for a few minutes
remove thread protector on shroud adapter to screw on an airgun suppressor with M18x1 threads.
UTG
UTG | .22/Airgun to Picatinny/Weaver Low Pro Snap-in Adaptor Mount
$12.99
•
.22/Airgun Dovetail to Picatinny/Weaver Rail Adaptor
•
Innovative Rail Platform to Convert Most .22/Airgun Rails
•
Top Slot with Spring Tension Retraction/Expansion Design to Snap into Picatinny/Weaver Base
•
Extremely Low Profile and Lightweight
•
Precision and Repeatable Alignment
•
Easy Installation with Most .22/Airgun Rails, 2PCs/Set
•
Removable Stop Pin for Extra Secure Installation
UTG
UTG | Dovetail to Picatinny/Weaver Rail Adaptor Mount
$14.99
$15.99
• Matte Black Anodized 6061-T6 Aluminum Construction
• 3.94" Scalloped 9 Slot Picatinny Rail with 0.59" Saddle Height
• Compatible with Most 9mm - 11mm Flat or Round Dovetail Rails
• Full Length Locking Side Plate for a Secure and Repeatable Zero Hold
• Optional Recoil Stop Pin Provides Additional Retention Against Bidirectional Recoil
Western Airguns
Western Airguns | Sidewinder Moderator adapter
$44.99
The Western Airguns Sidewinder moderator adapter is a premium quality accessory designed to replace the factory moderator and provides a conventional 1/2” UNF thread. This to allows the Sidewinder to accept an after-market airgun moderator. Includes Thread Protector End Cap.